Introduction | Preface | Contents | Acknowledgements | Issue Details | TSSEA Home Page
Acknowledgements
This Code of Practice was prepared as a result of an initiative by the Committee of Management of the Thermal Spraying and Surface Engineering Association. For this purpose a special Health and Safety Committee was formed, chaired by Dr F J Blunt. The following people contributed to the production of this booklet
Tom Ashworth Malbeth Ltd
Noel Bickley NB Services
Jane Blunt, Chair University of Cambridge (formerly employed by TWI)
Mark Cole BOC Gases
Geoff Creffield Consultant
Chris Davies
Health and Safety Executive
Gareth Davies Praxair TAFA Technologies
Bob Easterby Health and Safety Executive
Jeff Fairweather Health
and Safety Executive
John Gent Rolls-Royce plc
Chris Guest Praxair
Surface Technologies Ltd
Keith Harrison Sulzer Metco (UK) Ltd
Anthony Herbert Sulzer Metco (UK) Ltd
Ivor Hoff TSSEA
Richard
Jones IOSH (formerly employed by Rolls-Royce plc)
Doug Keyworth
Dowding and Mills Engineering Services
Phil Lavin Monitor Coatings Ltd
Steve Lees HNTS
Terry Lester Metallisation Ltd
Ron Lucas
Rolls-Royce plc
John Powell Health and Safety Executive
Mike Round
South Staffs Industries Ltd
David Sansom Sermatech Ltd
Andy
Sturgeon TWI
Adrian Weatherill Sermatech Ltd
Dave Winder Q Coat
Ltd
The following people contributed to the revised edition, 2014:
Andrew Cole TSSEAMike Round South Staffs Industries Ltd
Ken Lawson University of Cranfield
Terry Lester Metallisation Ltd
Mark Cole BOC Gases
Steve Bomford Sulzer Metco
Ray Bowen Praxair
Terry Hirst Aero Engine Controls
Mark Gee National Physical Laboratory
Melissa Riley TWI Ltd
Tiziana Marrocco TWI Ltd
Note: "A Code of Practice for the safe installation, operation and maintenance of Thermal Spraying Equipment" is published by the TSSEA. To publish the document to this web site significant reformatting for electronic viewing has been necessary. The content of the document is, however, unaltered.